HYDRAULIC PRESS Series P
This press has a compact and elegant structure, made of steel, stove-enameled at 180° with epoxy paints.
Its functioning is entirely hydraulic and completely automatic with the exception of the loading of the material to be pressed.
The pressing force is exercised by a hydraulic cylinder at the back part of the press and on which the die is mounted.
The mould, located on the working table, is filled manually with the powder to be pressed and after the pressing, the sample obtained is extracted by means of a die in the lower part.
Electronic control panel, permitting a completely automatic operation of the press (except for the loading of the powders to be pressed).
- Hydraulic extractor
- Electronic control panel, permitting a completely automatic operation of the press (except for the loading of the powder to be pressed).
By means of the electronic control panel, 5 different working cycles can be memorized. For each of these working cycles, the following parameters can be set:
- Working pressure
- Three layers of powders; this means that it is possible to press three different types of powders simultaneously and electronically control the thickness of the layer in the mould.
- Dearaetion pressure
- Dearaetion time
- Residence time at the required working pressure
- Automatic start of the pressing cycle
The working pressure is indicated on the display
It can be supplied with interchangeable moulds in various sizes:
100 x 100 mm. - 150 x 150 mm. - 100 x 200 mm.
Provided with scraper and keys for the assembly and disassembly of the mould.
(All data contained herein are not binding. The manufacturer reserves the right to modify any of them).